[NEW GUIDE] A Step-by-Step on Getting 3dB Beamwidth Right in Real-World Teleport Operations

For teams running or managing teleports, antenna tracking performance is not theoretical. It directly affects link stability, actuator wear, power usage, and whether a control system behaves predictably or constantly overcorrects.

That reality is why Radeus Labs’ engineers created the Parabolic Satellite Dish Antenna 3dB Beamwidth Measurement Method guide.

This resource exists to help operators verify one of the most foundational parameters in any antenna control system using real, measured data instead of assumptions.

Why This Guide Exists

Most antenna control systems rely on the -3dB (half-power) beamwidth as a core input. Step sizes, deadbands, scan patterns, and corrective movements are all derived from this single value. When it is wrong, tracking performance degrades in subtle but costly ways.

In many systems, beamwidth is populated using a theoretical calculation based on dish diameter and operating frequency. That approach assumes near-perfect antenna conditions. In real teleports, antennas experience panel settling, feed changes, sub-reflector movement, waveguide losses, and mechanical wear over time. As a result, the theoretical beamwidth often does not reflect the antenna’s actual performance in the field.

The Radeus Labs guide was created to close that gap by providing a clear, repeatable method for measuring beamwidth as the antenna truly performs.

What the Guide Helps You Do

This engineering guide walks operators through a proven field process to determine accurate -3dB beamwidth values and apply them correctly within an antenna control system.

Inside the PDF, you’ll find:

• Why -3dB beamwidth is critical to step-track and beacon-based tracking
• When beamwidth should be revalidated during an antenna’s service life
• Equipment and setup requirements to avoid distorted measurements
• A step-by-step method for identifying peak power and half-power points
• Guidance on interpreting differences between azimuth and elevation beamwidths
• Instructions for calculating corrected values and entering them back into the controller

The process is designed to be practical, repeatable, and aligned with how modern control systems actually use beamwidth internally.

Who This Guide Is For

This resource is intended for:

• Teleport operators responsible for GEO tracking performance
• Engineers supporting antenna control systems and step-track optimization
• Teams troubleshooting unstable tracking or excessive actuator movement

If your system requires constant tuning, exhibits unexplained hunting, or no longer performs the way it once did, validating beamwidth should be one of your first diagnostic steps.

Why Measurement Matters

Accurate beamwidth measurement is not about perfection. It is about aligning your control system with the antenna you have in the field, not the one described on a datasheet.

By measuring instead of assuming, operators gain tighter tracking behavior, reduced overcorrection, improved link margins, and earlier visibility into mechanical or RF degradation. Over time, those improvements compound into more predictable operations and lower maintenance costs.

The Radeus Labs guide exists to make that process accessible without guesswork.

Download the Engineering Guide

If you are responsible for antenna tracking performance and want your system to reflect real-world antenna behavior, this guide was built for you.

Download the Parabolic Satellite Dish Antenna 3dB Beamwidth Measurement Method and put a proven engineering process behind one of the most important parameters in your teleport.